Kair Plenum Elbow Bend Adaptor 234mm x 29mm to 100mm - 4 inch Rectangular to Round 90 Degree Bend Adapter

Kair Plenum Elbow Bend Adaptor 234mm x 29mm to 100mm - 4 inch Rectangular to Round 90 Degree Bend Adapter

RECTANGULAR 234mm x 29mm

The flat end is a female spigot and fits over 234mm x 29mm Rectangular Duct Pipe Part: DUCVKC706.

ROUND 100mm / 4 inch

Circular end is a 100mm round female spigot. 100mm male fittings (bends etc) will fit directly into this spigot.

100mm round duct pipe Part: DUCVKC250 or flexible hose Part: DUCP0092/102/35 can be connected to this spigot using a 100mm Round Connector Part: DUCEK28.

Allows you to convert between round and rectangular ducting systems.

Made in the UK using high-quality Polystyrene/Polypropylene plastic.

Max / Min Temperature: +60c / -15c.

Easy to install and durable, just push-fit duct and fittings together.

For permanent fixings, seal joints with silicone sealant or tape.

Airflow performance independently tested by BSRIA or BRE.

Suitable to use in compliance with Part F Building Regulations.

Static Pressure Drop in Pascals: 15 l/s = 11.08 Pa - 30 l/s = 38.22 Pa - 60 l/s = 132.45 Pa.

Perfectly suited for ducting your Bathroom or Kitchen extractor fan, hydroponics, in-line extract Fans, tumble dryer, or cooker hood.

Designed to be low profile to fit inside ceilings, floor slabs, or to be concealed above kitchen wall units.

This item can be used as a part of a long ductwork run for a variety of purposes including whole house ventilation, passive stack vent, positive input ventilation, air conditioning, HVAC, and Heat Recovery systems.

Kair plastic rigid ducting is perfect for DIY and Trade use and provides superior airflow performance and durability versus flexible duct.