Skip to content

Club members get 15% off when you spend £75 or more on thousands of products online. Not a member? Join now >>

400ml Anchor Bond Adhesive Chemical Studding Polyester Resin Mortar Anchoring UK

Sold & shipped by SKM DIRECT
Available online only and not stocked in B&Q stores
£8.89£8.89 per kg

Product details

Product information

Description: A polyester resin, 2‐part, rapid curing, chemical anchoring system. Applied in one single action to produce a cost effective, tough chemical resistant fixing. Uses Suitable for setting bolts, studs, wall ties, starter bars or large screws, etc into a wide range of substrates. Compatible with brickwork, concrete, masonry, stone and PFA blocks. Hollow base materials can also be securely fastened using ANCHOR BOND in conjunction with a sleeve or sieve. Chemically resistant, waterproof and vibration proof. Preparation Drill a hole to the correct diameter and depth (see chart over leaf), ideally using a rotary percussion machine. For optimum results the wall sides should be thoroughly roughened. Clean hole and remove all dust and debris using a hand air pump or a stiff rotary brush, if required. All bars should be clean and free from oil or grease and all flaking rust should be removed. Threaded rods or studs should be chisel ended to prevent them being unscrewed from the cured resin. Application Screw the mixing nozzle on to the cartridge (hand tighten). Place the ANCHOR BOND cartridge into the dispensing gun. Squeeze the hand trigger a few times until material passes through the mixing nozzle. Allow the material to flow until an even colour is obtained (normally 5-6 inches). Insert the nozzle into the base of the hole and extrude material, half filling the hole with resin. Withdraw the nozzle then insert the fixing into the filled hole, slowly rotating to fully coat the surface. After application release the pressure from the dispensing gun.

  • Guarantee - 1 month

Specifications

BrandBond it
Weight (g)1000g
Product code5060021363541