Charnwood 10'' x 7'' Planer Thicknesser

A solid and well finished planer thicknesser for the busy workshop. Precision ground cast iron beds and a long tilting fence which can be positioned at any point across the table make this machine a delight to use. The 3 knife cutterblock is powered by a 2hp induction motor and is capable of a cut up to 5mm deep in a single pass. To gain better visibility and access for thicknessing, both of the planing beds are hinged and swing out of the way, without using any tools. A dust hood / cutter guard is then swung into position and the conversion to Thicknesser is complete. The feed roller drive, which features a rubber outfeed roller, can be disengaged during planing operations to save motor power and general wear on the machine. Supplied with 3 knives, 100mm dust extraction outlet, 4 adjustable feet, 1.6m power cable and UK 3 pin plug. Our planer thicknesser will run off any standard 13amp supply. It is essential to use dust extraction with a planer thicknesser. The extractor removes all the dust and chips which will otherwise build up, causing a blockage and eventually damage to the machine. Using an extractor also increases the life of the knives. ** Charnwood W583 Specification: Surfacing width 250mm (10″), Length of surfacing tables 1085mm, Maximum depth of cut 5mm, Fence tilt 90 – 45 degrees, Table height 856mm, Thicknessing capacity 5-195mm (1/4″-7″), Length of thicknessing table 600mm, Feed speed 5.5m/min, Maximum depth of cut 2.5mm, Cutterblock speed 4000rpm, Number of knives 3, Motor ( induction) 1500w (2hp), Assembled Dimensions (WxDxH) 1100mm x 780mm x 1050m, Assembly Time Required 45 Minutes (Needs 2 People), Weight 150kg, Shipping Crate Dimensions (WxDxH) 1130 x 500 x 740mm, Minimum Door Access Width 450mm, Rating Trade, Product Guarantee 5 Years.