57 people bought this in 48 hours
Colron Refined Jacobean dark oak Matt Furniture Wood dye, 500ml
Mix & match - 3 for 2 on selected interior and exterior paint. Hurry, ends Thursday.
Product details
Product information
You can apply this wood dye from the Colron Refined range to , using a cloth or sponge, to colour and provide protection. It takes 1 hour to dry.
- Guarantee - Statutory
- Suitable for All types of wood
- Surface Preparation - Surface Preparation - Colron Refined Wood Dye is only absorbed by clean, dry, untreated timber which is free from dirt, oil and grease. Any previously applied finish such as paint, varnish, seal polish or wax must be completely removed. Prepare the surface well. Colron Refined Wood Dye and compatible varnishes provide a transparent finish any marks, blemishes or stains in the substrate will show through. Any discoloured wood should be sanded until an original surface is visible. Sand lightly in the direction of the grain taking care not to over sand or “polish” the surface. Oily hardwoods such as teak, resinous areas and knots should be thoroughly washed with white spirit. Remove any dust using a brush or vacuum cleaner and wipe the surface using a cloth soaked with white spirit. Allow to dry thoroughly.
- Instructions for Use - Colron Refined Wood Dye can be applied with a soft cloth or sponge. When treating large areas such as doors or floors apply the dye one length of floorboard or a section of door at a time to avoid overlaps, work quickly to maintain a wet edge. Application by cloth or sponge will result in a lighter shade. A one coat application is normally sufficient, but colour may be intensified and a more even finish achieved by the application of further coats of Colron Refined Wood Dye. Allow 1 hour between coats. Do not apply more than three coats. Seal the dye using Colron Refined Interior Lacquer. When treating floors use Ronseal Diamond Hard Clear Floor Varnish. Allow the dye to dry for 1 hour prior to application of varnish.
- Guarantee - Statutory
Features and benefits
- A water-based acrylic wood dye for unfinished or bare interior wood
- Penetrates deeply into the wood to produce a deep, rich colour
- Contains fade resistant, non-yellowing pigments for lasting colour
- Quick drying
- Low VOC
- Apply by cloth
Legal information
- Contains 1,2-benzisothiazol-3(2H)-one and reaction mass of 5-chloro-2-methyl-2Hisothiazol-3-one and 2-methyl-2H-isothiazol-3-one (3:1). May produce an allergic reaction.
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
DetailsSpecifications
| Brand | Colron |
|---|---|
| Colour | Jacobean dark oak |
| Coverage | 32m² |
| Location | Interior |
| Drying time | 1 h |
| Recoat time | 1 hour |
| Finish | Matt |
| Durability | Medium duty |
| VOC level | Low |
| Base | Water-based |
| Application method | Cloth or sponge |
| Container type | Tin |
| Washable | Wipe clean |
| Volume | 500ml |
| Product code | 5010214853212 |
Safety Information
Manufacturer / EU responsible person
Reviews
4.14 / 5(14 reviews)Gunger - 5 / 5 - 02/05/2024
Excellent stainer. A little goes a long way
Easy to apply and a very even finish . Would use again
streak - 5 / 5 - 28/02/2024
Staining wood
Item is easy to apply and gives good coverage. Colour very evenly spread.
JBman - 5 / 5 - 18/01/2024
Great product
Great product, i found it easy to apply and colour is good
BlueLouis - 5 / 5 - 13/09/2023
Wood dye that dyes wood
Well, what more could I ask for? I did exactly what I wanted
decpainter - 5 / 5 - 02/07/2023
Fantastic wood dye applied with sponge the more cg
Will not leave any brush marks too also used ther wood lacquer too
Diydiydiymountain - 5 / 5 - 19/03/2022
Great. Easy to go on. Looks good!
First time used. Easy to use. Goes on well. Low vocs which was important.
MrsEvs - 5 / 5 - 07/02/2022
Good wood stain!
This stain is good , easy to apply and as I have never stained wood before I found it easy to achieve a darker colour by just adding more until I liked the effect . I would describe the colour close to an actual walnut though although I was not fussy on how it turned out . A happy customer
Cat44 - 5 / 5 - 10/05/2021
Did the job brilliantly & easy to use
I read all of the reviews on this one and almost didn't bother, as they're not actually very good. Anyhow, I had a pine bookcase I wanted to dye to a darker colour to match our new furniture, rather than buy new. Yep OK, I had to do about 5 coats to get it as dark as I wanted, but it soaks in and dries so quickly, it only took me about an hour and a half. I applied it with a micro fibre cloth. Went on really easily. Comes off hands with ease. Finish looks great! Matt, not shiny. Exactly what I wanted. No it won't do it in one coat, but keep going until you get the colour you need. Does exactly what it says on the tin. Really good stuff! Glad I chose it.
- 5 / 5 - 08/11/2020
Transformed my kitchen
I was really skeptics to purchase this product and want to dye my existing oak wood, what a fantastic product ... after taking the time to sand down and clean my existing worktop it looked like a new kitchen by the time I finished! Really impressed, the prep work massively helps and does make w huge difference, if your prepared to but in the graft then buy the product! It gives a very rich dark wood look, just what we wanted.
Destained - 2 / 5 - 16/08/2020
Patchy finish at best
I needed a dark oak colour to apply to a self made pine desk table top to match it with other dark oak furniture. I had a shed full of wood dyes, but sadly, when I applied them to a sample of the wood, none were the right colour. I tried a few other locally available dyes, all of which looked stunning on the wood, but didn’t match the other furniture. I left the Colron range until last as it was more expensive, but the Jacobean Dark Oak appeared to be a good match, so eventually I picked up a 250ml tin. Upon opening the Colron dark oak I immediately noticed the thick consistency. This makes the product difficult to even out when applying it to the wood. Once applied, the colour appears very patchy despite 3 careful coats being applied over a number of days (pine board - see picture). The dye smells like it is water based, which is different to the Colron antique pine I had in the shed - I had already tried the antique pine on an off cut of the wood in case multiple layers or a mix with other dyes I had would make the right colour so I know that the old spirit based Colron applies evenly. The table top is destroyed, even after hours of effort trying to get the colour even - I wish I had gone with a contrasting colour instead - at least the colour would have been even. I don’t often do reviews, but I am so disappointed with the results of this product, I felt compelled to let others know about it.