Curved edge worktop jig
This beige acrylic & chipboard curved edge worktop jig is designed for guidance on how to cut a curved edge on a worktop and is suitable for all solid kitchen worktops.
- Guarantee - 1 year
Features and Benefits
- Made from responsibly sourced, Forest Friendly timber
Health and Safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Material||Acrylic & chipboard|
Used to cut countertop ends for a Cooke @ Lewis
Dan G - 3 years ago
Good for the price. The radial isn't a perfect match, but you'd need to look from underneath to notice (2cm overhang start and finish, 4cm mid radial). You'll need a couple of clamps, there are no locating pins, a test position on a spare piece to gauge the start point. More awkward is finding a decent router bit!!!
jw51 - 3 years ago
Bought to put curved ends on eathstone worktops. Adequate for the job, but limited life expectancy as it is only MDF.
CDAndover - 3 years ago
I bought this to make the fitting of the worktop above the curved cupboard, as simple as possible. My fitter informed me that the curve of the jig did not match the curve of the cupboard. Very disappointing.
not fit for purpose
dicktin - 3 years ago
having bought a kitchen with curved base units I thought it would be best to buy a jig from B&Q assuming it would be the correct radius for your own cupboards.
This was not the case. It turned out to be nowhere near and so was useless.
I had to pay to have a jig made.
Frosty00001 - 3 years ago
This product had a curved edge which was to tight for cutting corners with curved base units. I have returned the item