See more Fillers
Diall Solvent-free Coving Adhesive & filler 310ml
This coving adhesive & filler is suitable for all lightweight polystyrene and polyurethane coving, mouldings and ceiling centres.
- Guarantee - 1 year
Features and benefits
- Good initial grab, covers 4-6 metres
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
Waste of money
Em2847 - Today
Didnt stick atall and then the coving fell on the tv so the adhesive went all over it so had to clean everything off. Do not buy! Back to b&q i go...
Cornish Kid - 31 days ago
I used this product for sticking and filling polystyrene coving, works perfectly, painted the coving. Its been up for over a month and no problems at all. Because my house is very old and the ceilings not flat, a couple of places had to use small nails to temporary hold it into the shape, but again no problems with either sticking or filling.
Very poor product
Spartacus1234 - 1 month ago
This product states adhesive and filler, it sticks no problem but when you paint over it (leave 48 hrs) anything you used as a filler above or below just cracks away from the wall or ceiling. Had to remove and fill with a filler
waltsv - 1 month ago
Doesn't grab have to use pins, when it dries it leaves cracks had to clean it all off and start again
Good Adhesive if used properly
Zanzan - 2 months ago
You have to put a few small nails or pins along the bottom length and the top to keep the coving from sliding down the wall. Make sure there is no adhesive on the wall or ceiling when you fill the gaps as the adhesive will dry quite quickly so use a wet sponge to clean any excess.