See more Flush Doors
Flush Ply veneer Internal Door, (H)1981mm (W)686mm
Will add style to your living space whilst providing privacy and protection from sound and draughts throughout the house
- Guarantee - 10 years
- Fixings not supplied
Features and Benefits
- Ready to stain or varnish
- Made from responsibly sourced, Forest Friendly timber
Health and Safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Height (mm)||1981 mm|
|Width (mm)||686 mm|
|Thickness (mm)||35 mm|
|Weight (g)||14000 g|
|Door construction||Hollow core|
|Timber approval||FSC® approved|
Andrew75 - 1 year ago
Do not be fooled by the description, these doors do not have a plywood outer layer. They consist of a single wood veneer stuck to a cardboard substrate with an expanded paper core. They are of ply construction (wood on cardboard) but they are not what one would expect. On the good side they are lightweight and properly finished. Two of the 4 doors I ordered were partly crushed; I thought that the first one was my fault, but the second was definitely partly dished on delivery; do make a careful examination after unpacking. Overall they are superficially perfect, but they are not robust, and will not take much day-to-day knocking about. The doors did not come with a finishing instruction, but a larger one that I ordered in the same series did. You are meant to paint ALL surfaces, including any mortice lock recess, within 3 days of hanging - how you paint the underside of a door or the inside of a mortice lock recess once a door is hung is beyond me. Finally, these doors were of different thickness to the larger one so if, like me, you are hanging several, do check the thickness.
Cheap but good enough
JimGUK - 2 years ago
We needed a door that would fit in a narrow doorway. This was close width-wise but 6" (15cm) too high. The scant instructions said to not cut off that much but we had no choice.
We cut off the top then stripped off the 'wood' from the end piece and glued it back in the space. This has worked well.
The lock block is relatively small and located lower than other doors but it was just possible to align the knob hole with other existing doors.
The instructions said not to use a spade bit but we also had to ignore that 'suggestion' since we had no other bit. By taking it slow and easy there was no problem.
We finished the door with a matt varnish and it now matches well with the other 3 adjacent doors
Overall we consider £24 to be a fair pice for the door even though we had to work around it's issues.
Handy basic internal door
LowTech - 2 years ago
I bought this recently for an internal garage workshop door because it had exactly the width I wanted, and the possibiloty of modification (ideallly I wanted a shorter door but could not find anything suitable).
It might be useful to give this info: this GEOM door is ~34mm thick, quite light, and should be planed by no more than 6mm from the bottom edge up to 4mm off each side. It has a glued softwood internal frame, a composite material covering with very thin wood veneer, and a 'honeycomb' paper filling. The frame material is only about 22mm wide hence the warning on trimming. On delivery the door though well wrapped, was only very slightly bowed but not excessively. It should be 'acclimatised' before use, and must be painted after fitting.
I needed to shorten the door by 6" and acheived this successfully by cutting out one side only (at the bottom) ~5½ inches, but leaving the frame and other side intact to keep the door true, then inserting a new lower stile cut to fit exactly, inbetween the two sides. I clamped it to to glue flat overnight. I then cut off the unwanted 6" and trimmed it. This made the lock mounting block effectively 6" lower but that was wide enough ( 320mm x 60mm) to put a ball-catch at its highest point. The door was mounted with 3 hinges as recommended for moisture susceptible areas, and is just the job.
Very satisfied with value, and ease of modification!
Great Smooth Door
DIY ETTE - 2 years ago
This grained door was perfect for the bathroom. It just needed sanding down and several coats of paint later it was great !
Great Smooth Door
DIY ETTE - 2 years ago
Exactly what was needed. Smooth surface and I am now in the process of painting the door.
Exmoor Flush Wood effect Grey Sliding door, (H)2040mm
The foiled finish is resistant to most greases and stains Sliding doors are a perfect solution for small spaces sturdy construction to withstand everyday use Sliding system sold separately
Flush 1 Panel Oak Veneer Internal Unglazed Door,
Will add style to your living space whilst providing privacy and protection from sound and draughts throughout the house Guarantee - 1 year Fixings not supplied
Flush 5 Panel Oak Veneer Glazed Internal Standard
Allows light to penetrate through from one space to another which is ideal for dark hallways Guarantee - 1 year Fixings not supplied
Flush Ply veneer Internal Fire Door, (H)1981mm (W)686mm
Provides a blank canvas for you to add colour to suit your personal taste, whilst providing 30 minutes of fire protection when fitted in accordance with manufacturer's instructions Guarantee - 10 years