Save on kitchens, bathrooms and bedrooms. Thresholds apply. Look out for the offer tag on qualifying products. Shop now >
See more Frost & water proofers
G4 Pond Waterproof Sealer 5Kg Paint Concrete Bonding Sealant Coating Plastic
Sold & shipped by Aquatix-2u
Available online only and not stocked in B&Q stores
Product details
Product information
G4 Pond Sealant is durable, deep bonding plastic coating for concrete, brick, and porous stone (not suitable directly onto concrete blocks, these need to be cement rendered first). G4 uses the moisture in the air and substrate to cure or harden so it can be applied to slightly damp substrates. G4 can be applied in poor weather conditions, high humidity and at temperatures down to 0°C. Consumption of G4: (Uncoloured). 3 coats = 550g/m² (for all 3 coats). Specifications Finish: Clear Weight: 5kg
- Guarantee - Statutory
- Will store for many years if suitably stored unopened in original container. NOTE; this is a moisture-hardened product so storage life of opened tins is limited.
- Apply by brush or roller. G4 should be applied onto a bare, clean and dry substrate. Existing coatings, paint or other treatments should be removed. Any loose pointing in brick work should be replaced or worn areas in floors repaired. For most sealing purposes 3 coats are recommended. Each coat can be reapplied when the surface is finger tacky. Do not allow 4 hours to elapse between coats. Clean equipment with Rustins Cellulose Thinners. Turpentine or White Spirit are unsuitable.
- Keep out of reach of children. Avoid ignition sources. Do not spray. Do not inhale vapour.
- Legal information: Flammable. Irritant. Avoid contact with eyes and skin. Wear protective gloves and eye protection. In case of contact with eyes, immediately rinse with plenty of water and seek medical attention. After contact with skin, wash immediately with soap and water or a suitable skin cleanser. Keep out of reach of children. Avoid ignition sources. Do not spray. Do not inhale vapour.
Features and benefits
Durable deep bonding plastic coating for concrete without the need for a primer.
May be applied at low temperatures.
Forms a non-porous seal on rendered concrete, brick or porous stone.
- Quick & simple
- No primer needed
- Can be used at low temperatures
- Seals out lime 550g covers approximately 1 sq. metre
- Easy to use
Legal Information
- Flammable. Irritant. Avoid contact with eyes and skin. Wear protective gloves and eye protection. In case of contact with eyes, immediately rinse with plenty of water and seek medical attention. After contact with skin, wash immediately with soap and water or a suitable skin cleanser. Keep out of reach of children. Avoid ignition sources. Do not spray. Do not inhale vapour.
Specifications
| Base | Polymer-based |
|---|---|
| Coverage per litre | 1.1m²/L |
| Drying time | 60-90 min |
| Location | Interior & exterior |
| Maximum application temperature | 50°C |
| Minimum application temperature | 1°C |
| Number of pieces | 1 |
| Product weight | 5100g |
| Recoat time | 15-30 minutes |
| Product code | 5014197122266 |
