See more Grout
Mapei White Anti-Mould flexible grout (W)5kg
Our stores do not stock this product
This 5000g anti-mould flexible grout is use with underfloor heating & timber floors on for ceramic tiles, natural stone & porcelain. Simply apply and leave for up to 5 hours to dry. Each pack covers up to 39 m² on average.
- Guarantee - 1 year
- Resistance - Mould and water resistant
Features and benefits
- Cement based anti mould flexible grout
- Water repellent (drop effect) Mould resistant with Bio Block Technology
- Full wet area usage after 48 hours
- For joints 2-20 mm. Pot life 35 minutes
- Good wear and abrasion resistance. Domestic & commercial application
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Drying time||Up to 5 hours|
|Location||Internal & external|
|Coverage||Up to 39 m²|
A very poor product
Anonymous - 4 months ago
I brought this product to complete a tiling job I was doing. Having previously purchased another brand for the bathroom, when it came to the utility room I could not find this brand so ended up purchasing this product from Mapei. From the moment I prepared my first mix I realised just how gritty (cheap ingredients) this product was and no matter how it was applied and smoothed out it has a very rough finish when it dries out. This will only help attracted dirt, grime and mold during use and is probably the underlying course behind the previous review. The gritty material used makes the end product porous. It also does not give a true white finish (cheap ingredients) when the product dries. If this was a cheap product then I'd say you get what you paid for, but it's not. B&Q do sell cheaper brands and they are all a better product than this one.
Do not use this in Bath or shower areas
Anonymous - 6 months ago
I bought this grout and used it it for the tiles in my shower after a few months I noticed that the plasterboard to the side of the shower was getting damp under further investigation I then noticed that the plaster board on the walls behind the tiles are soaking wet due to the grout not being waterproof. I contacted the company and was told that this is only waterproof if used in a bathroom that is fully tanked and waterproofed before the tiles go on others is no mention of this on any of the packaging). I now have to either dig out and regrout or re-tile the whole area
Very good product
PeterB58 - 4 years ago
I used one and a half, 5Kg bags on 4 fully tiled walls in my bathroom, including shower compartment. Stick to the instructions for mixing. If extra water is needed add only a tiny bit at a time, thoroughly mixing each time as it's easy to over do it. I found that the mix stayed workable for longer than stated on the pack but only mix what you can use and finish in an hour. It adheres well and sets to a hard durable surface that gives me more confidence than other grouts I have used. As previous review, be careful that you get the colour that you want. It's not that obvious on the packet.
tspservices - 4 years ago
we use this product on all tiling jobs, and its absolutely fine. CHECK COLOUR on the bag first, or it may dry ' a different colour ' ; )
J0NNY5 - 6 years ago
If I could rate this product 0-stars I would; be warned if you are expecting this product to be ‘white’ then be prepared to be disappointed. This product dries a silvery grey!
I recommend using the Unibond Ice White or Bal products instead.