See more Light switches

Home

Right chevron

Switches

Right chevron

Light switches

Right chevron
Left chevron
Zoom inZoom outZoom reset
MK 10A 2 way White Single Light Switch
Right chevron

MK 10A 2 way White Single Light Switch

£2.25
Loading
Checking availability...
Loading
Checking availability...

Product details

Product information

Raised screwed profile light switch with plastic gloss white finish. 1 gang internal switch, ideal for controlling 1 circuit. 2 way switches make it possible to control the same light from 2 locations.

  • Location: Internal use

Features and benefits

For your safety, electrical products must be installed in accordance with local building regulations. If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self-certification scheme.

  • 20 year Guarantee

Specifications

BrandMK
Model name/numberK4871 WHIS3
ColourWhite
Pack quantity1
ProfileRaised
Number of ways2
Screwed/screwlessScrewed
Power voltage supply240V
Number of gangs1
Amp rating10A
Product code5017490328472

Reviews

Full star
Full star
Full star
Empty star
Empty star
2.85 / 5(21 reviews)

Product is Fine

Full star
Full star
Full star
Full star
Full star

DaCo - 10 days ago

There's a lot of negative reviews but I think it's possible most are user error. You need to use the right tools for these. If you try and use a dainty little screwdriver to fix the wires you won't be able to turn the screws, you need a full size one with as wide a bit as will work, likewise for the fixing screws. I bought six and they've all worked perfectly.

Terrible

Full star
Empty star
Empty star
Empty star
Empty star

unhappyinstevenage - 2 months ago

What were they thinking? The screws are almost impossible to turn.
Couldn't figure out how to connect the wires till read some reviews on here, you have to try and force the screws through the thread, must be a finishing issue at the factory.
Once done they are ok.

Simple

Full star
Full star
Full star
Full star
Full star

Neil The Peel - 10 months ago

I bought 3 of these, despite the negative comments in earlier reviews, and was glad I did. They look a lot better than the aged and dated brass switches I was replacing. I didn't have any problems with the screws in the connectors. I just loosened and tightened them a couple of times, with a good quality screwdriver. It was simple.

Excellent Product

Full star
Full star
Full star
Full star
Full star

Malky46 - 1 year ago

The name MK says it all, well designed ergonomically and of good quality, ok the terminal screws are a bit stiff at the start (MK CAN YOU EASE THEM IN AT PRODUCTION) but it is no big problem using the correct size screwdriver. The bad reviews on the terminal screws are I expect from DIYers and not electricians. These look good and operate smoothly. Fitted these on a bungalow rewire and would not have used if they were no good, leave adequate tails and no problem.

Alright once id figured how to wire it up

Full star
Full star
Full star
Empty star
Empty star

Roger 2020 - 1 year ago

HI. I have one of these switches and was scratching myhead for a while figuring our how to get the screws to tighten on to the wire. After reading the reviews on here I had another go and it works fine. The screws come out of the packet in an open position and need tightening to clamp the wire in place. There is a strong resistance in the housing and it appears the screw is at its lowest point. You then need to gently apply presure being careful not to round off the screw and it will tighten further allowing it to come low enough in the housing to clamp the wire adequately. Slight head scratcher but a bit of gentle force sorted the problem and the switch works fine

  1. Show all customer reviewsRight chevron