Ronseal 5 Year Fence Life+ Sage Matt Exterior Shed & fence Protector Wood paint, 9L Tub

Product information

Ronseal 5 Year Fence Life+ Shed & Fence Protector provides 5 years of protection for your shed and fence with just two coats. It's simple to use and stands up to all kinds of weather. The first coat protects, and the second coat seals, giving you up to 5 years of deep, rich colour with no peeling or flaking. Sage gives your fence or shed a soft green finish that fits naturally with plants and borders. It’s a simple, calm shade that helps the garden feel tidy and consistent. Fence Life Plus+ can be used on all rough sawn and smooth planed wood whether its new, stained with a similar colour, or even damp.

• Guarantee - Statutory
• Suitable for Wood
• Waterproof
• Surface Preparation - Wait for a warm, dry day (above 10 °C and not going to rain). Cold, wet weather stops the stain from drying, which could make it wash off. Use a stiff brush to clean off any dirt and previous coatings that are peeling or flaking. Giving your wood a good clean makes sure the stain will soak in and stick properly. You could clean the wood with either a pressure washer (be careful not to damage the wood) or use a suitable fence cleaner. The stain is best applied to wood that is completely dry, however if your wood is damp to touch, then it can still be applied. Cover anything you don't want to get stain on. To check you're happy with the colour, find a small hidden patch of wood to test on before you paint your whole shed or fence.
• Instructions for Use - To apply with a brush, give it a really good stir. Use something wide, like an old wooden spoon. Get lots of the stain on your brush and put a good thick coat on. If you see any drips, brush them in. Give any drips on plants or paving a wipe with soapy water before the paint dries. On rough sawn wood, you'll need to use 2 coats to get 5 years protection. For smooth planed wood, you'll need to use 3 coats. leave 4 hours between coats. To apply using a sprayer, you'll need to make sure it's not too windy. Give the stain a really good stir, then pour the liquid into the tank. Pump it up or turn it on and start the spraying. Use long, sweeping. horizontal arm movements and move along the full width of the panel. Drop down and do the same again, going over again where you've already sprayed about half. This will make sure the whole area is covered with just the right amount of stain. On rough sawn wood, you'll need to use 2 coats to get 5 years protection. For smooth planed wood, you'll need to use 3 coats. leave 4 hours between coats. Any overspray should be cleaned up straight away with soapy water before it dries.

Features and benefits

• Colour that lasts for up to five years
• Protects in all weather
• Dry and showerproof in about 1 hour, and ready to recoat in 4 hours
• Suitable for use on all sheds and fences, even on damp wood
• Simple application using a brush or sprayer
• Stands up to rain, frost and snow and won't lose its colour in the sun
• Safe to use around plants and pets
• With 2 coats on rough sawn or 3 coats on smooth planed wood, the colour will last for up to 5 years. If you're covering a dark or bright colour, you'll need more coats.