Tower 15mm Electrolytic Inline Scale Inhibitor Boiler Limescale Pipe Tube

• 6 months Guarantee

Features and benefits

Genuine original 15mm electrolytic inline scale inhibitor from Tower, for use with heating appliances such as water to water heaters and hot water circuits of combination boilers.

Specifications:

WRAS approved product

Maximum working pressure: 10 bar at 20°C

Made in Great Britain

Service life: Up to 10 years

Saves on energy costs

No chemicals or power needed

Easily installed

No moving parts

No maintenance required

15mm compression fittings

Dimensions: 170mm x 26mm diameter

Installation:

Ensure the unit is installed so as to be readily accessible for examination, test, maintenance or replacement. The unit may be fitted horizontally or vertically. It is not directional. Choose a pipe run long enough to accommodate the unit. An approved single check valve or other no less effective back-flow prevention device shall be fitted at the point of connection between the supply and the unit. To ensure a leak proof installation, make sure the pipe is cut square with a pipe-cutter even if the pipe run is initially broken into using a hacksaw. Tighten fittings with a 24mm spanner.

Part L of the Building Regulations (conservation of fuel and energy for dwellings) states that where the mains total water hardness exceeds 200ppm, provision should be made to treat feed water to water heaters and hot water circuits of combination boilers to reduce the rate of accumulation of limescale and to limit its harmful effect on energy efficiency. Electrolytic scale inhibitors are listed in the Domestic Building Services Compliance Guide as a suitable control. As water flows through the unit it emits charged zinc ions which induce hardness salts to cluster together and pass through heating appliances rather than forming limescale deposits on the heat exchanger or water heating element. Service life is dependent upon local water conditions and water usage.

• Genuine Tower 15mm Electrolytic Inline Scale Inhibitor
• Use with heating appliances such as water to water heaters and hot water circuits of combination boilers
• WRAS approved product
• Maximum working pressure: 10 bar at 20°C
• Service life: Up to 10 years
• Saves on energy costs
• 15mm compression fittings
• Dimensions: 170mm x 26mm diameter