See more Tiling Adhesives
This floor tile adhesive & grout is waterproof and suitable for ceramic floor tiles, max size 300 x 300 mm.
- For use on - Concrete & cement screed floors & pre-fitted underfloor heating
- Recommended for - Bathrooms, kitchens and hallways
- Heat, water and mould resistant
- Suitable for splash areas and suitable for use with underfloor heating
Features and Benefits
- All in one - Tile adhesive and grout
- High bond strength
- Suitable for pre-fitted underfloor heating
Health and Safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Drying time||48 hours|
|Ready to grout||48hours|
Easy to use
Ali128 - 1 month ago
This is so quick and easy to use, even for someone who has never tiled before. It leaves a lovely finish and looks really smart.
DO NOT BUY! - read the reviews
Abi44444 - 2 months ago
This product is horrendous. I bought 4 tubs without reading the reviews due to knowing Unibond is a reputable company & for the price of the product. We spent half a day putting tiles down for them to be easily pulled back up 4 days later - the adhesive was still wet under parts of the tiles! We then had the task of removing the adhesive from our 30+ tiles! Please do not waste your time, energy or money on this product!
Ghator - 2 months ago
It was too gritty and dry. Didn't spread well and definitely didn't cover the area it was supposed to. I now have to break some tiles and replace them as they have not stuck down well.
THIS REALLY IS A RUBBISH PRODUCT
Long time DIYer - 4 months ago
Foolishly bought this product on name without reading previous reviews. Impossible to spread evenly at Unibonds recommended maximum depth of 3mm. Sticks to the substrate ok but only sticks to the tiles where it touches. Some tiles needed relaying others have obvious voids which will probably result in cracked tiles later on. I cannot recommend this adhesive. Best use powder an mix to a workable consistency.
Tiler Dave - 4 months ago
Usually use the powder stuff but only a small awkward job so went for the readymixed. The adhesive Drags on the floor, falls of the tile, you can’t lay a decent area. Threw it away, cleaned up the tiles and used the powder. Wasted a day on a job that would only take half a day.