See more Light Switches
Varilight 10A 2 way Polished copper effect Single Light Switch
Our stores do not stock this product
This flat screwless low-profile switch in polished anti-microbial copper is ideal for controlling 1 circuit, the 2-way ability makes it possible to control the same light from 2 separate locations. The Anti-Microbial range from Varilight has been designed for use in hospitals, care homes and other environments where control of pathogens and acquired infection is a priority. Anti-Microbial Copper continuously kills pathogenic microbes and inhibits the build-up and growth of bacteria, achieving an 99.9% reduction within two hours of exposure between routine cleaning and sanitising steps. Please note: This surface will tarnish unless cleaned regularly.
- Location: Internal use
- Only fixings included
Features and Benefits
- 1 or 2 way switching
- Suitable for controlling both mains and low voltage lighting
- Anti-microbial copper achieves 99.9% reduction in bacteria within 2 hours of exposure
- Sleek, low-profile screwless faceplate
- 1 year Guarantee
- Can be used with either a 1 or 2 way circuit
|Number of ways||2|
|Power voltage supply||230V|
|Number of gangs||1|
Amywill - 5 months ago
Flimsy and tarnished after a week of use. Every mark visible including finger prints that do not come off. Hubby says very poor to fit and don’t sit flush to the wall..save your money
Feel too flimsy
RRC - 1 year ago
Poor quality, I kept these just because they were the only copper ones I could find but they aren't great, very flimsy and leave a gap. Would probably only work if u have a perfectly flat wall. I had to return one because it was marked on the actual switch. I'll be emailing b&q to inform them too
Primary1 - 1 year ago
Purchased 5 of these because they look great but the quality is very poor and feels cheap, the toggle switch is loose and floppy and the finish was tarnished and smeared during manufacture. They also show every single finger print and look awful after a few uses. Lastly, they are not easy to install as the top plate is a push fit onto the small plastic tabs, it takes a lot of faffing to get a perfect “click” fit and because of the design there is a visible gap between the switch and wall surface.
I will have to return them all, it’s going to cost me for the electrician again.