Woodstikk D4 Waterproof PVA Glue - 5kg

Product information

Woodstikk D4 PVA Adhesive meets the requirements of BS EN204 category D4 for water reistance, EN 14257 (Watt 91) for bond strength, and EN 14256 for creep resistance. Woodstikk D4 PVA Adhesive can be used for many woodworking applications where a high level of water resistance is required, and has been successfully used for hot and cold pressing applications in the manufacture of windows, doors, cabinets, furniture and surface bonding for laminating applications. Woodstikk D4 PVA Adhesive can also be cured using radio frequency equipment.

• Guarantee - Statutory
• Suitable for Cardboard, chipboard, paper, veneer & wood
• Clean machines, equipment and tools with water before the adhesive dries. Woodstikk D4 PVA should be stored in the original containers in a cool, dry place, at a temperature range of between 10°C and 30°C. In these conditions it has a storage life of at least 3 months, but it is important to note that Woodstikk D4 PVA does have limited stability and is prone to thickening. Woodstikk D4 PVA must not be allowed to freeze and ideally should be warmed to at least 15°C before use.
• Ensure that the surfaces to be bonded are smooth, clean and free from dust or other deposits. Wood, plywood, laminated plastics should be of uniform thickness. Some dense hardwoods may require sanding before bonding. For best results the moisture contents of the surfaces to be bonded should be in a range of 7 – 13%, but when pressing at temperatures above 105°C, moisture content should not exceed 10%. Moisture content variation between adjacent components should not be > 3%. Woodstikk D4 PVA should be applied evenly to one substrate using a brush, hand roller or mechanical roller. Adhesive coverage between 80 and 180g sq/m are suitable depending on the surfaces to be bonded. When bonding different timbers, such as teak and high-density hardwoods, the adhesive should be applied to both surfaces of the joint. It should be noted that adhesive spread has considerable influence on both assembly and setting times. Ideally open assembly time should not be more than 5 minutes Lay the items to be bonded together within the workable time and press them for as long a time as is needed to achieve the required handling strength. The pressure should be high enough to ensure contact of the parts over the entire area of the joint. Allow 24 hours for full strength to develop. Higher levels of water resistance form more slowly and should be tested not earlier than 7 days after bonding. Woodstikk D4 PVA, like all other PVA adhesives, may tend to show structuring especially in cold conditions. This effect is generally reversible on slight stirring. Additionally, there may be some increase in viscosity, but this will not detract from the application properties or performance.
• This product is not classified as hazardous

Features and benefits

Woodstikk D4 PVA is a single component PVA wood adhesive with excellent water resistant characteristics.

• Excellent water resistance - EN204 D7
• Excellent bond strength - EN 14257 (WATT 91)
• Excellent creep resistance - EN 14259
• Quick curing
• Excellent bond strength on hard and soft woods
• Cures with radio frequency equipment