See more Paint


Right chevron


Right chevron
Left chevron
Cuprinol Sprayable Black Matt Exterior Wood paint, 5L Tin
Right chevron

Cuprinol Sprayable Black Matt Exterior Wood paint, 5L Tin

Sold & shipped by B&Q

per l
Checking availability...

Product details

Product information

    This Cuprinol One Coat Sprayable Fence Treatment has been specially formulated to work with sprayers to colour and protect rough sawn timber in a fraction of the time. Its special pigments ensure a rich colour and even coverage in just one coat, so you spend less time treating your fence, and more time enjoying your garden.

    • Colours & protects rough sawn timber against weathering
    • Suitable for Wood
    • Remove loose or flaking material. Make sure the surface is clean (no dirt or grease) and dry.
    • Shake the pack thoroughly before use. Final colour will depend upon wood type, previous treatment and the number of coats applied. Apply using the appropriate Cuprinol sprayer for the product. As with any sprayer it may take a couple of minutes to perfect your technique. Ensure you stand at the correct distance with the nozzle 15-30cm (6"-12") from the wood surface. Begin slowly and increase the pace as you get used to spraying. Take care not to spray too quickly as this may result in an uneven finish. Similarly, spraying too slowly will result in excess product being applied causing runs. Should this happen, simply brush into the wood. Avoid spraying surrounding plants, brickwork, glass, PVCu, etc. Overspray can be minimised by avoiding spraying in windy conditions and by using cardboard or plastic as a shield. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. Excessive spillage on plants should be rinsed off immediately before drying. If applying by brush, apply evenly, avoiding splashing surrounding plants, brickwork, glass, PVCu, etc. Do not apply in temperatures below 5C, in damp conditions or if rain is likely before the product has dried. Cover any surfaces nearby to protect from overspray. Allow 2-6 hours between coats under normal weather conditions. Where a strong colour change is involved, more coats may be required. Product performance will be reduced if applied to grey and weathered smooth wood. If using more than one pack it is advisable to mix them together in a larger container or finish in a corner before starting a new pack.
    • Guarantee - Statutory

    Features and benefits

    • Grease proof
    • Stain resistant
    • Washable
    • Water-based
    • Easy to apply

    Legal Information

    • Contains C(M)IT/MIT(3:1). May produce an allergic reaction.

    Health and safety

    Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.


    Application methodBrush or roller
    Colour groupBlack
    Container typeTin
    Drying time5 h
    Paint typeTreatment
    Recoat time2-6 hours
    VOC levelLow
    Product code5010212650912