FLEXIBLE FLOOR LEVELLER WITH LATEX 25KG
Product details
Features and benefits
- Rapid setting, flexible and crack resistant
- Ready to use, just add water
- Pedestrian traffic after 4 hours, ready for floor covering after 24 hours
- Self levelling - no separate latex required
- Can be laid between 2mm and 20mm thickness
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
Details
DetailsSpecifications
| Brand | Tarmac |
|---|---|
| Coverage | 5m² |
| Drying time | 2 h |
| Location | Internal |
| Material | Latex |
| Pack quantity | 1 |
| Standard | CE marked |
| Weight (kg) | 25kg |
| Product code | 5030349010267 |
Reviews
1 / 5(4 reviews)MarkA1980 - 1 / 5 - 24/03/2018
Doesn’t self level!!
The key characteristic of self levelling compound... it self levels. Used as directed and mixed for 3 minutes, came out like cement. Did the same with three bags, three different consistencies. Afterwards, went and got another product, went down like a dream. The product is sub standard.
Zzzeke - 1 / 5 - 27/09/2016
Total rubbish
Store ran out of my usual brands so I took a punt.... Followed mixing instructions, stuff is utter rubbish. Does not even come close to self leveling unless massively over-watered and then fails to set hard enough for duty. Needed breaking out and had to re do the job with proper compound.
Sadface321 - 1 / 5 - 19/08/2016
Rubbish
This product is rubbish. Doesn't flow even when watered down,just sinks to ottoman of mixing bucket. Spicked roller didn't help. Had to go over with another,and a bit cheaper, product. But cost a lot more in the end. Don't buy!!
Integrity Builders - 1 / 5 - 07/05/2016
Absolute rubbish
I have used this twice this week, the first time I assumed I had not put enough water with (put the amount specified) it as it did not flow very well at all set far to quickly and did not level off. Next time I added more more water but it still did not level or flow. I even used a spiked roller. I would not use again or recommended indeed avoid. It would be easier to level using gripfil.