Gas Push Fit Gas Regulator 21mm Calor Gas

# Gas Push Fit Regulator with Dial Gauge

**Technical information:**

This is a single-stage 21mm push fit gas regulator preset to 28mbar to EN12864. Please note that the regulator is only suitable for gas bottles with the following type of fitting:

## How to connect 7kg, 12kg, and 15kg Gas Bottles

- These cylinders have a 21mm valve and should only be used with 21mm regulators.

- Remove the orange dust cap by pulling the lanyard out and then upwards; avoid using tools for this, and just leave the cap hanging.

- Check that the black sealing washer is fitted inside the cylinder valve.

- Make sure the regulator switch is in the disconnect position (3 o'clock position).

- Fit the 21mm regulator as the manufacturer's instructions suggest.

- When you need to use gas, turn the switch anticlockwise to the 'on' position.

**IMPORTANT:**

If the regulator on/off switch gets stuck when turning the supply on, it means the regulator has not been connected correctly. If this happens, disconnect it and follow the instructions to reconnect it.

## How to disconnect 7kg, 12kg, and 15kg Gas Bottles

1. Turn the regulator switch clockwise to the off position.

2. Remove the 21mm regulator as the manufacturer's instructions suggest.

3. Replace the orange safety cap onto the empty bottle valve.

**Weight:** 190gr

*Please check our other listings for different types of regulators.*

**Product Code:** G530

**EAN:** 5704122000102