See more Floor Levelling Compounds
Tarmac Floor levelling compound, 25kg Bag
Our bulk delivery service requires a minimum order value of £100 across any combination of bulk delivered products. You can change the quantity in the basket.
Features and benefits
- All debris, dust, oils etc must be removed to ensure good adhesion to the substrate
- Coverage 5m² at 3mm thick or 3m² at 5mm thickness
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Drying time||3 h|
50% success rate
Bullfrog - 2 months ago
Bought two bags of this product roughly two weeks apart. First bag was fine. Once i got the second bag home discovered it had already partially set in the bag, had to take it back, possibly a faulty batch maybe, bought a similar product different brand instead. So check the bag before buying in store.
Unfit for purpose
BigRedDarryn - 4 months ago
This product did not mix properly. Separated into grey water and sand. After 24 hours it was not even set properly so I’ve had to scrape it up and buy a different make.
Utter rubbish -doesn't level if used as instructed
RHLon - 5 months ago
Ran out of Mapei Ultraplan half way through a job so I tried this. Mixed to instructed proportions and seemed nice and liquid. But when poured it was hopeless at self-levelling. I had to remove it. Total waste of time and money. If using again I'd increase water to 6 or even 7 litres. But I'm not trying it again.
Perfectly smooth level floor
old BtB - 6 months ago
First time using this product and it worked perfectly. I used it in my kitchen on a very rough concrete floor to cover over an old sunken hearth prior to tiling. Height difference of over 20mm in places running out to a feathered edge.
Cleaned down to bare concrete, vacuumed all the dust then epoxy primed.
Mixed exactly as per the instructions on the bag, 5 litres of water to 25Kg, and this is the key - using a paddle mixer in the SDS drill to get a nice even mix.
It does not need additional water if mixed correctly (it was too thin and settling out if I stopped mixing at approx. 20Kg to the 5 litres).
I was only doing a small 5m2 area and found that it self levelled fast as I trowelled it out. I used 3 bags, mixed a bags worth at a time and poured it out as fast as I could mix it.
It has set to a very nice smooth and perfectly level surface with no difference in finish between the thickest and thinnest areas and has bonded well to the old concrete.
Perfectly level floor
Tinbum1960 - 8 months ago
There is nothing wrong with this product, please do not blame it if you don't do the job properly. I have used countless bags of self leveling up to 200m2 on one job. You MUST prime the surface with the correct primer, not PVA or other rubbish. You MUST mix it with a paddle mixer in a proper leveling bucket, not a toy DIY drill with a tin mixer. You MUST use a spikey roller to take out the trowel marks and level the surface. DO NOT use more water in the mix, it is not necessary and only weakens the self leveling. DO NOT use on a wet floor, always check the moisture content and use a liquid DPM if required. Finally do not use over bitumen, old adhesive, Marley tiles etc there are specific self leveling compounds for these.