See more Mortar


Right chevron

Building supplies

Right chevron

Cements & additives

Right chevron


Right chevron
Left chevron
Volden Rapid set Mortar, 5kg Tub - Requires mixing before use
Right chevron

Volden Rapid set Mortar, 5kg Tub - Requires mixing before use

Sold & shipped by B&Q

per kg
Checking availability...

Product details

Product information

    Volden Rapid Set Mortar is ideal to do small and easy mortar work for emergencies and repairs. Simply fill the bucket with water to the required volume, add the powder and mix.

    • Guarantee - Statutory
    • Resistant to frost
    • Ensure any loose material or debris is removed and brushed prior to application of mortar. When repairing pointing joints the depth of the joint should be twice the width. To help prevent the mixed mortar drying out too quickly in warm conditions, dampen bricks, blocks and bases before proceeding. Recommended application temperature is 5 to 25°C. NOTE: This product is pre-blended and requires no further mixing before adding water. 1) Open bucket, removing dry mortar mix bag. Dependent on required volume of mortar, fill plastic tub with clean water to required level using internal water mark indicators. NOTE: Refer to mix ratio table for details on expected consumption. 2) Empty contents of bag and mix thoroughly until the desired consistency is achieved. 3) Once mixed evenly, apply Volden Rapid Set Mortar with a trowel and/or palette knife to the prepared area. Ensure mortar is evenly distributed. 4) On completion, cover newly laid masonry with polythene sheet or wet hessian (sacking) to protect from weather hazards until fully set. Remove any excess material from the surface of bricks, paving etc. before the mortar dries. 5) Clean tools and equipment with warm soapy water immediately after use.
    • General purpose Mortar applications where quick setting is required
    • Danger Causes skin irritation. May cause an allergic skin reaction. Causes serious eye damage. If medical advice is needed, have product container or label at hand. Keep out of reach of children. Do not breathe dust. Wash skin thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear protective gloves and eye/face protection. IF ON SKIN: Wash with plenty of water and soap. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor. If skin irritation or rash occurs: Get medical advice/attention. Take off contaminated clothing and wash it before reuse. Dispose of contents/ container to an approved waste disposal plant. Refer to product SDS

    Features and benefits

    • Rapid set mortar for all types of mortar repair
    • Easy to use water fill markings inside the tub
    • Ready to use, just add water and mix in the tub
    • Can be used for emergency pointing, brick replacement, fixing slabs
    • Sets within 45 minutes
    • Can be used for interior and exterior applications

    Health and safety

    Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.


    Application methodTrowel
    Colour groupGrey
    Drying time2 h
    LocationInternal & external
    MaterialAdditives, cement, minerals & sand
    StandardBS EN ISO 9001
    Product code5063022039873