Charnwood 5/8'' Bench Top Morticer with Sliding Bed

Bench top hollow chisel morticer with an accurate sliding table system.

Adjustable Down feed Handle

Table Moves Through X and Y Axis

Cast Iron Head, For Strength & Stability

Cast Iron Table, Hard Wearing For A Long Life

Cast Iron Fence, For Secure Work piece Clamping

Cast Iron Base, For Fixing to a Workbench

Plunging Head Controlled by Gas Filled Spring

Quiet Induction Motor Delivers The Power

Using Cast Iron throughout gives the strength and rigidity to this morticer, to allow timbers of up to 125mm deep and 145mm high to be clamped securely.

There are two separate controls for moving the table.Firstly the operator winds the table forwards or back until the chisel is aligned with the back edge of the mortice.Secondly the hand wheel is turned to move the table left or right until the chisel is positioned at one end of the mortice. Pulling the downfeed handle lowers the chisel and begins the cut. Once the first square has been cut, the chisel is withdrawn, and the table moved over to begin the next square.

Supplied with, mortice depth stop, handle return stop, chuck key, work clamp, 3/4" chisel bush, cable and plug. Chisels are supplied separately.

Charnwood W316 Specification

Accepts chisel shank size 3/4″

Motor Speed 1400rpm

Motor (induction) 370w (1/2hp), 240v

From Chisel Bush to Table 220mm

Maximum timber height with a 1/2″ Chisel Fitted 110mm

Timber Clamping width 25mm (1″) to 100mm (4”)

Chisel capacity 1/4″ to 5/8″

Vertical Chisel Stroke 105mm (4”)

Accepts chisel shank size 3/4″

Table travel (left to right) 170mm (6.5”)

Table travel (front to back) 75mm (3”)

Motor (induction) 370w (1/2hp), 240v

Motor Speed 1400rpm

Weight 42kg

Dimensions (WxDxH) 520mm x 550mm x 790mm