Charnwood W650 10'' Professional Cast Iron Table Saw

For the small professional workshop. The main table is precision ground cast iron to give a flat surface that will last forever. The surface area is further increased with the addition of 2 steel extension tables offering greater support when working with larger panels and boards. The guide fence for ripping operations slides smoothly along a solid steel bar with a measuring scale marked out in millimetres. The fence itself can be used in two positions. The sliding mitre fence is adjustable to 60 degrees in each direction. It has preset stops to locate it accurately at 45 degrees and 90 degrees. The fence itself can be locked at any angle from 90 to 45 degrees, and there is a positive stop to ensure the fence returns back to the 90 degree position. A work clamp ensures timber stays locked in position during the cut. The power is generated from a 2200w (3 hp) induction motor which gives a low noise level and will run from any standard 13amp, 240v power supply. Setting the sawblade angle and height is done using two separate hand wheels.A large easy to read scale on the front face of the machine allows accurate bevel angles to be set. Supplied with 36 tooth TCT sawblade, push stick, rip fence, mitre guide, 1.8m power cable and UK 3 pin plug. Charnwood W650 Specification: Main Table Size 750mm x 1000mm, Maximum Ripping Width Using Fence 605mm, Crosscut Table Size 400mm x 180mm, Maximum Crosscutting Width 550mm, Blade Tilt 90 – 45 degrees, Cutting Depth at 90 degrees 80mm, Cutting Depth at 45 degrees 56mm, Blade Diameter 250mm, Motor (induction) Braked 2200w (3hp) / 240v, Dimensions (WxDxH) 1440mm x 1070mm x 1120mm, Weight 125Kg. It is highly recommended that a dust extractor is used at all times with this saw to prevent the harmful build up of dust and chips. Note: It is not possible to use a stacked dado set with this saw