Everbuild 405 Brick Stone Path Patio Cement Concrete Protector Seal 5L PAT5

EVERBUILD� 405 Path Patio Seal is a solvent free acrylic coating used to seal and protect patios, paths,

natural stone, concrete and block paving from the effects of sunlight, water, oil, petrol and organic growth.

The milky solution dries to a hard wearing water repellent film which gives a low sheen, slip resistant finish

which will reduce dirt pickup and facilitate easier cleaning.

The product is safer to use than conventional solvent based products, i.e. it is non-flammable and

will not harm plants and animals when used as directed.

USES

Where it will protect from the effects of sunlight, water, oil, petrol and organic growth on:

Paths

Patios

Natural stone

Concrete

Block paving

CHARACTERISTICS / ADVANTAGES

Solvent free formulation � non-flammable, low odour.

Improves appearance of paths/stone.

Also acts as a dustproofer and facilitates easier cleaning.

Dramatically improves water and mark resistance -

High degree of water repellency in dried film.

Contains a powerful fungicide � prevents unsightly growth in the film.

M.F.F.T ca 0�C

Drying Time 4 Hours

APPLICATION INFORMATION

Consumption 1 Litre will cover approximately 8m� per coat depending on nature of surface

APPLICATION INSTRUCTIONS

SUBSTRATE QUALITY / PRE-TREATMENT

Surfaces must be free from grease, dust, loose material, algae etc. Clean surfaces with Everbuild Patio Wizard. For bad oil stains, use a proprietary detergent

such as EVERBUILD OIL AWAY and hot water.

For very badly soiled surfaces, use Everbuild Brick Patio Cleaner.

In all cases, wash down the cleaned surface with a hose and broom to remove all traces of cleaning product.

Pavers must be left for three months minimum after placing before over coating with this product.

This will allow salts to leach out which otherwise may cause unsightly white patches appearing beneath the sealer, especially when the patio is wet.

APPLICATION

Stir well before use. May be applied to damp (but not wet)