See more Tile Backer Boards
HardieBacker Cement Board is a backerboard for tile and stone, used as an alternative for plasterboard for tiling floors, bathrooms/wet rooms and masonry walls. Backerboard can also be used to tile bath panels or as a decorative lining sheet for multi-fuel/log burning stove installations
Features and Benefits
- Won’t rot, swell or warp when exposed to moisture
- MouldBlock ™ Technology protects the job from dangerous mould growth
- Can hold 100kg m2 while conventional plasterboards claim to hold up to 32kg m2
- HardieBacker 12mm can also be used on the floor when additional height is needed, behind a boiler, or even behind a multi-fuel or log burning stove
Health and Safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Fire Resistance||A1 non-combustible|
|Impact resistant||Impact resistant|
|Moisture resistance||Water resistant|
|Suitable for||Internal use only|
BEST FOR THE JOB
IMMY5526 - 1 year ago
BOUGHT THIS TO TILE ONTO. PLACING IT ON THE FLOORBOARDS AND TILING OVER. VERY STURDY AND STRONG. NO MOVEMENT VERY HAPPY
Great Product, but very very expensive!
Cat lover Pam - 1 year ago
Very disppointed, I bought 5 sheets as the label said £15 per sheet or £12 for 5 +, as my plumber had asked for 4 or 5 sheets and as the total price would be the same, I decided to purchase 5 sheets. After making this purchase, examination of my till receipt showed I'd been charged £16 per sheet with a discount for quantity of a little over £9. I have complained to the store, but so far had no response. The product was very good, but very very expensive!
Easy to use and cut , great board
kosta - 1 year ago
I bought this a few weeks ago and used to lay tiles over wood boards. Did the job properly and was easy to be used
Brilliant Backer Board
keviam - 2 years ago
Great board and easy to use apart from bloomin hard to snap small bits but overall great to lay and hang.
Best product for the job
Grandpa Joe - 2 years ago
I used this to line the opening for a log burner. It's relatively easy to cut but make sure you follow the guidance which is printed (in very small text!) On each board as it gives off a lot of very fine dust.
Easy to fit using a good quality cement based time adhesive and takes paint well.