Jet Swet Water Flow Prevention Device For 15mm + 22mm Pipes up to 75 PSI

Professional water flow prevention device for commercial or occasional use

Water flow prevention device

Allows engineers to work on live pipework

Designed to temporarily isolate the flow of water in pipes

Designed to temporarily isolate the flow of water in pipes to allow you to work on the removal, refitting or soldering of valves or fittings

Suitable for use on 15mm and 22mm pipe work

Temporarily seals outlets from cold water cisterns to enable downstream service valve removal / replacement

Perfect for use as allows you to not have to drain the cistern / whole system

Seal feed / expansion cistern pipes when flushing central heating systems

Seals pipe work to aid in commissioning and pressure testing of new installations

Allows soldering of pipe work that would otherwise prove difficult due to water seeping into a joint

Seal supply pipe work that would otherwise prove difficult due to water seeping into a joint

Seal supply pipe work up to 75 PSI to enable gate and full bore isolation valve replacement

SPECIFICATIONS

• Water flow prevention device
• Temporarily seals outlets
• Suitable for use on 15mm and 22mm pipe work
• Simple and easy to use
• Seals pipe work to withstand 75 PSI of pressure

SIMPLE TO USE

1. Reduce water flow – ensure the valve is in the open position and insert jet swet into the pipe

2. Securely hold locking sleeve using the correct sized wrench and tighten handle until it cannot be rotated any further

3. Unthread / unscrew or unsolder valve to be removed (when soldering ensure that the gasket is inserted at least 100mm away from the naked flame)

4. Make any alterations to pipe work as required