See more Sheet Metal
Steel Panel (L)0.5m (W)500mm (T)1mm
Our stores do not stock this product
- Guarantee - 1 year
Ideal for car body repairs
graham101 - 2 years ago
Thick enough to weld, thin enough to bend.
I measured in store using a vernier gauge which showed it to be just a small fraction under 1mm thick.
Used it to weld a few patches into my car. Easy to cut with an angle grinder and trim with aviation snips. I was able to bend right angle bends using a bench angle bender and produce other contours using a hammer and vice.
I welded the patches in using a MIG welder without blowing holes all over the place and ground it back.
Ended up with an invisible repair.
Very pleased :)