TIKKURILA Anti Reflex 2 - Flat Matt, High-Opacity, Ceiling Paint - Zero Flash - 3 litre

• Instructions for Storage - Protect from frost and direct sunlight. Store and transport in tightly closed containers at temperatures between +5°C and +25°C. Close can carefully for next use. The product should be transported and stored in containers protecting against weather in temperature between +5°C to +25°C. The product must be transported and stored in containers, which protect it against influence of atmospheric conditions. The storage and transport temperature must be between +5°C and +25°C. Protect the paint against frost. Close tightly the packaging immediately after use. Tightly closed packaging should be stored in room with temperature not lower than +5°C and not higher than +25°C, protect from frost and direct sunlight.
• Guarantee - Statutory
• Surface Preparation - Unpainted surfaces (putty surfaces, plaster, concrete and chipboards, fibreboards and gypsum boards): clean these surfaces from dust and loose particles. Prime with Tikkurila Optiva Primer or Tikkurila Anti-Reflex white [2] thinned with water up to 20%. Previously painted surfaces with dispersion, alkyd and oil paints:Wash the surface before painting and remove grease. Remove flaking fragments, sand the surface and clean with water. Sand glossy surfaces with mid-grained sanding paper. Clean the surface with water and let to dry. Surfaces painted with glue or lime paint: Remove thoroughly the lime or glue paint till the plaster. Smooth out irregularities and losses with putty. Prime the whole surface with Tikkurila Optiva Primer or Tikkurila Anti-Reflex white [2] thinned with water up to 20%. Spackling and filling the losses: It is recommended to check if the used putty is strong and stable surface – if after delicate hand wipe the putty is falling or leave the dust on hand then it means that the surface is loose and it has to be primed with Tikkurila Suprabilit. On the previously painted surfaces please make a test painting on the small surface. The positive effect of the test decide on the use of the product. Notice: Don’t start application if the surface temperature is lower than +5°C.
• Guarantee - Statutory

Features and benefits

• Non-dripping/non-splashing formula
• Optically eliminates the surface imperfections
• Low odour
• High-opacity, long-lasting professional finish
• Anti-reflexive, latex paint for interior walls and ceilings
• Can be applied with a brush, roller or spray
• Water-based formula certified with the M1 eco-label (indoor air quality)
• Touch dry in 30 minutes recoat in 3 hours