See more Fillers
Diall Coving adhesive & filler 1000ml
Our stores do not stock this product
This coving adhesive & filler is suitable for all lightweight polystyrene and polyurethane coving, mouldings and ceiling centres.
- Guarantee - 1 year
Features and benefits
- Good initial grab, covers up to 10 metres
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Litre capacity (ml)||1000ml|
Did exactly what I needed it to do.
LFC_Sparky - 1 month ago
Bought this product on a recommendation from a friend who had also used it. After reading the reviews on here already, I was very sceptical it was going to work. Like a previous reviewer I struggled with the first piece I fitted. After measuring and cutting pieces to fit I used small notice board pins to hold in place. I would then mark a line with a pencil along top and bottom edges then run a line of adhesive just inside the line as I found it difficult to run it along the actual coving (I found cutting the nozzle on a slight angle helps to make it stick to wall and ceiling). Then you can push the coving against the adhesive and the line helps you get it into the right place. If any presses out use your finger to press it back, running your finger along it, it also seals the edge.
Should be withdrawn from sale
majon - 2 months ago
This adhesive is not fit for purpose, it has virtually no adhesive qualities whatsoever, you're probably better off using chewing gum ! Do not waste your money on this product.
Not fit for purpose
MarcosD - 3 months ago
Spent so much time holding the coving in place to get it to bond that my neck and shoulders hurt. Very user unfriendly, if you put a lot on it seeps out to make a mess and not enough it won't stick. Poor adhesive. Avoid.
No problem if you use it correctly
Frannieod - 3 months ago
I bought this product with my coving - first time doing this job so watched the videos and apart from the first 2m length, everything went smoothly. One video recommended putting 3 or 4 small tacks just under the coving to hold it in place until the adhesive was dry. Great tip - just pull them out afterwards. The adhesive does grab well but I think I didn't use enough on my first 2m length. I'm really happy with the result.
Just the Job...again!
Petersan - 5 months ago
Still folk write on here that this product is no good, just completed my daughters kitchen taking almost 20 metres of coving with 4 lengths over 2.4 metres. All put up by myself with no problem at all....can not understand why people are having issues!