Black Friday deals have landed!
See more Glues & adhesives
Diall Gel Superglue 3ml
Sold & shipped by B&Q
A specially formulated non-drip adhesive with precision nozzle, which can be used to bone a wide variety of materials such as rubber, metals, leather, wood, plastics.
- Guarantee - Statutory
- Suitable for Metals, plastics, porcelain & rubber
- Make sure the surfaces to be bonded are clean and dry (it is preferable to solvent-wipe plastics, glass, rubber and to acid-treat metals). Place cap on tube and tighten to pierce the metal seal. Dispense a drop or droplets to one surface only. Apply only enough to leave a thin film after compression. Press parts together and hold firmly for approximately 10 seconds. Good contact is essential. An adequate bond develops in less than one minute (maximum strength is achieved in 24 to 48 hours). Wipe off excess adhesive from the top of tube and re-cap. If left uncapped the product may deteriorate from contamination to moisture in the air
- Keep the adhesive in a cool, dry place between 20°C and 25°C. For long-term storage, refrigeration (5°C) is recommended
- P102 - keep out of reach of children. P261 - avoid breathing dust, fume, gas, mist, spray and vapours. P264 - wash hands thoroughly after handling. P271 - use only outdoors or in a well-ventilated area. P280 - wear protective gloves, protective clothing, eye protection and face protection. P302+P352 - If on skin: Wash with plenty of soap and water. P304+P340 - If inhaled: Remove person to fresh air and keep comfortable for breathing. P305+P351+P338 - If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. P312 - call a doctor, a poison centre if you feel unwell. P321 - specific treatment (see supplemental first aid instruction on this label). P332+P313 - If skin irritation occurs: Get medical advice/attention. P337+P313 - If eye irritation persists: Get medical advice/attention. P362+P364 - Take off contaminated clothing and wash it before reuse. P403+P233 - Store in a well-ventilated place. Keep container tightly closed. P405 - Store locked up. P501 - dispose of contents and container to hazardous or special waste collection point, in accordance with local, regional, national and/or international regulation. EUH202 – cyanoacrylate, danger, bonds skin and eyes in seconds. Keep out of the reach of children
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|Bonding strength||Excellent bonding strength even when vertical|
|Drying time||24-48 h|
|Maximum application temperature||80°C|
|Maximum heat resistance temperature||80°C|
|Minimum application temperature||-55°C|