See more Gas fires
Focal Point Langham full depth Chrome effect Manual control Gas Fire FPFBQ243
If you prefer the look of a real flame then this stylish gas fire is ideal for you.
- Guarantee - 3 years
Features and benefits
- To ensure a safe installation, your gas heating appliance must be fitted by a qualified gas installer (Gas Safe registered in the United Kingdom or Bord Gais registered in the Republic of Ireland) who should also verify the proposed site conditions are fully suitable for the product selected
|Chimney/flue required||Chimney or flue required|
|Control location||Front, behind ash pan|
|Fire recess requirements||(D)200mm (H) 540mm (W) 375mm|
|Gas fire fuel bed type||Coal bed|
|Switch type||Manual control|
Easy to use
Tinmix - 4 years ago
Had the fire for about a month and have found it easy to use and gives more than ample heat.Grate product. I know it's spelt wrong but it is fitting!
Spare parts trauma
BenMamma - 4 years ago
Whilst fitting the fire the ceramic back plate snapped (it is really flimsy). I tried contacting the maunfacturer - but they don't sell the back plate in the size needed. Basically a nice looking fire and belts a lot of heat out...but if the cermics break you're stuffed. (and they have to be removed once a year when it is serviced, so a real risk of this happening sooner or later)
Cosy and stylish
VivWi2016 - 5 years ago
Chose this fire to fit in our dining room. We don't use it every day, however it's a lovely cosy fire to sit in front of. Just like a real fire without the hassle of cleaning it out.
Great fIre but be aware
g12345 - 5 years ago
I bought this fire and it was fitted on 1st October by a registered gas filter. the first few weeks it was great, looks lovely and great heat but then almost overnight a large flame appeared at the back of the fire and there was a huge amount of soot produced. EVerything was black with soot. I was concerned and called british gas to check it. Turns out there was a screw not fitted properly and there was a small gas leak this caused the problems. The engineer had to strip the fire completely to fix it. So please be aware if you have any of these problems. I will be contacting the manufacturer as this was a factory fault. It's working great again and I'm very happy with it.