See more Fillers
Polycell Deep gap filler 1L
Our stores do not stock this product
- Suitable for filling and repairing joints, cracks and holes
- Can be used on walls and ceilings
- Ready to use with a filling knife
- No shrinking or sagging
- 1 year Guarantee
Features and benefits
Polycell Exterior Polyfilla is a tough multi-purpose filler suitable for all exterior masonry repairs. Ready mixed for instant use, it dries to a grey weatherproof finish that will accept bolts and screws and will not shrink or crack.
- Surface dry in 2 hours (depending on conditions)
- Fills holes up to 10 mm deep
- Waterproof and frost resistant
- External use only on masonry and concrete
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
|For use on||Plaster & plasterboard|
|Ready to use||Ready to use|
|Shrinkage||No shrinking or sagging|
|Drying time||4 hours|
Doesn’t do what it says
DItY - 8 months ago
I bought this instead of plaster to fill areas around 20mm deep around a hole in a wall. It doesn’t set unless you use very small layers.
Great filler but takes time to harden.
JohnD49 - 10 months ago
Best general purpose filler I have found. Lightweight, so it doesn't sag. Fills deep holes and easily sands very smooth. However, it takes an absolute age to harden. So you need to be patient. Allow two days for a 10 cm deep fill. Still, I suppose a thin layer of emulsion paint takes two hours to dry, so it isn't surprising deep gap polyfilla takes so long.
Does not dry
Kj987654321 - 10 months ago
I got this product as it suggests can fill up to 20mm deep gaps and is dry in 1-2 hours. As others have commented, dry time is much much longer. Suggest anyone looking to fill larger holes in a reasonable amount of time to look for another solution!!
Doesn't slump in deep holes but doesn't dry either
PhilipT - 2 years ago
Although it says on the label it fills holes in one application, five days after filling around new power sockets it is still weak and crumbly. I would have saved time if I had done the job in small stages (as it says in the detailed directions) and although non slumping, ordinary filler would then have sufficed..
Can take a long time to dry
Lordspace - 3 years ago
Nice texture and works nicely out of the tub, and it says that it dries in 1-2 hours, but that would only apply to a thin layer. Yet this is 'Deep Gap' Polyfilla. I wanted to fill in a hole left by a double socket that I had removed (back box as well) and even after two days a partially-filled hole had not fully hardened. I reckon it will take at least a week to fill this hole!